The mesh consists of a very thin wire mesh. The wires are so thin that they are barely visible to the naked eye. The latter is fully integrated (embedded) by rolling between 2 sheets of PVC. The PVC has a scratch-resistant layer. The shield is available with an adhesive or not to facilitate the installation on the support. It can be applied to glass, acrylic and/or polycarbonate manually or automatically. The Shield Screen covers the frequency band from 10 kHz to 10 GHz. The tighter the mesh, the more efficient it is in high frequencies. However, the loss of optical transparency is also more important. The recovery of mass/ ground is most often by drilling, with recovery by the fixing screws. Different finishes also allow a mass recovery directly on the mesh or via a bus-bar. Our new “micro adhesive” solution facilitates manual installation by limiting the appearance of bubbles. We recommend using the standard adhesive exclusively in automatic installation by rolling mill.
